Bending aluminium

[GtheD]

I'm looking for somebody to apply T shaped aluminium extrusion around the perimeter of a restored caravan door. This is seemingly impossible. Obvs it's the corners that are the problem.

Can anybody help or advise please?

[GtheD]

Ah. Ok. I'm based in Portsmouth. Would a shrinker/stretcher bend this. I can't see how it would feed in given the T shape?

[GtheD]

Thanks for responding It needs to go as pic:

The flat vertical part goes along the door edge. It curves round the corners of a door, two of which are 90 degrees, two curved as seen.

If I can't diy I'm quite happy to pay someone to do it but question is who?

Edited by GtheD on Friday 2nd December 13:08

Edited by GtheD on Friday 2nd December 13:18