ACT Carbon Airbox
Discussion
Hi All,
I have recently purchased an ACT Carbon Air-box, I'm just after a bit of advice around the fitting:
What's best way to drill the Carbon fiber? (start with a small drill bit and work up to the required size, drilling from outside in, using masking tape? (using sharp bits of course))
How did you go about re-connecting the Brake Servo and the Fuel pressure regulator?
Thanks in advance!
I have recently purchased an ACT Carbon Air-box, I'm just after a bit of advice around the fitting:
What's best way to drill the Carbon fiber? (start with a small drill bit and work up to the required size, drilling from outside in, using masking tape? (using sharp bits of course))
How did you go about re-connecting the Brake Servo and the Fuel pressure regulator?
Thanks in advance!
Thanks Guys, yes I plan on measuring at least twice and drilling just once!
I think it's like this as there's different brackets for different models, I know last time my T350 was in for a service they changed the bracket from one mounted off the starter motor to one mounted off the engine.
Cooper Green said:
Yes as i thought, my reply has been removed. good luck with the fitting and drilling.
Saw your reply before it was removed, have to say the quailty of this part is excellent.I think it's like this as there's different brackets for different models, I know last time my T350 was in for a service they changed the bracket from one mounted off the starter motor to one mounted off the engine.
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff