Windscreen washer pipes perished / brittle due To heat
Discussion
My Tuscan 2 central windscreen washer pipe has split in half and is sticking about 10mm up from the rubber grommet in the scuttle panel
I understand this is quite common due to the heat generated by the manifold - initially I superglued it back together and shrouded it with heat shrink tubing - unfortunately that split immediately!!
I have now purchased the replacement washer jet modified version (the single jet block that clips onto the wiper arms to replace the original bendy pipe) from Race direct and new tubing
Has anyone replaced the tubing under the scuttle panel and if so does the scuttle panel need to be removed or can you route it and have access with your hands in situ - if so does the scuttle come off easily and can someone explain how please?
I understand this is quite common due to the heat generated by the manifold - initially I superglued it back together and shrouded it with heat shrink tubing - unfortunately that split immediately!!
I have now purchased the replacement washer jet modified version (the single jet block that clips onto the wiper arms to replace the original bendy pipe) from Race direct and new tubing
Has anyone replaced the tubing under the scuttle panel and if so does the scuttle panel need to be removed or can you route it and have access with your hands in situ - if so does the scuttle come off easily and can someone explain how please?
Edited by MackieTVR on Saturday 13th February 12:58
My Tuscan 2 central windscreen washer pipe has split in half and is sticking about 10mm up from the rubber grommet in the scuttle panel
I understand this is quite common due to the heat generated by the manifold - initially I superglued it back together and shrouded it with heat shrink tubing - unfortunately that split immediately!!
I have now purchased the replacement washer jet modified version (the single jet block that clips onto the wiper arms to replace the original bendy pipe) from Race direct and new tubing
Has anyone replaced the tubing under the scuttle panel and if so does the scuttle panel need to be removed or can you route it and have access with your hands in situ - if so does the scuttle come off easily and can someone explain how please?
I understand this is quite common due to the heat generated by the manifold - initially I superglued it back together and shrouded it with heat shrink tubing - unfortunately that split immediately!!
I have now purchased the replacement washer jet modified version (the single jet block that clips onto the wiper arms to replace the original bendy pipe) from Race direct and new tubing
Has anyone replaced the tubing under the scuttle panel and if so does the scuttle panel need to be removed or can you route it and have access with your hands in situ - if so does the scuttle come off easily and can someone explain how please?
Edited by MackieTVR on Saturday 13th February 13:25
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff