Brake Pressure Sensors
Discussion
I'm looking for an off the shelf in-line brake pressure sensor take-off fitting if they exist.
-3 fittings at either end to suit the brake lines and then I believe that the thread for the pressure sensors is pretty universal amongst most sensor manufacturers?
Can anyone recommend anything?
-3 fittings at either end to suit the brake lines and then I believe that the thread for the pressure sensors is pretty universal amongst most sensor manufacturers?
Can anyone recommend anything?
I have done the calcs / made the spreadsheet for the physical set-up (I have designed the pedal box myself) but the brake pressure sensors will be going into my dash display. Maths channels can be made to show the current brake bias which can be used to validate the turns of the bias adjuster whilst out on track. I can get the sensors without too much issue but I haven't yet found an in-line, affordable adaptor to fit them in.
Thanks gents, yeh the male-male T with a female take off in the centre to suit the -3 sensor is what I'm looking for but as of yet I haven't found anyone selling them.
Plenty of all male T's you can buy so I will probably end up getting one of them with a short length of hose in between with female ends but that adds a couple of extra fittings and length of hose to buy - it's close to an extra £50 quid for the two braking circuits.
Plenty of all male T's you can buy so I will probably end up getting one of them with a short length of hose in between with female ends but that adds a couple of extra fittings and length of hose to buy - it's close to an extra £50 quid for the two braking circuits.
Gassing Station | UK Club Motorsport | Top of Page | What's New | My Stuff