Hazard switch wiring

[sukhjeevan]

Can anyone advise on wiring up a none factory hazard warning switch?

The factory switch has 8 connections and I'm looking to use a switch with only 2.

[sukhjeevan]

Looking to purchase a flush fit savage switch

[sukhjeevan]

I plan to put my hazard switch in the roof panel (rectangular plate with 3 holes) and so need something that is flush fit and fairly shallow.

So I would need a small flush fit single pole switch that would operate a double pole type relay. Similar to this...

http://www.ebay.co.uk/itm/Hazard-Flasher-Relay-Red...

Can anyone see any issues with this arrangement as wiring as not my strength?

[sukhjeevan]

So in theory I could purchase just the savage hazard switch block and use a switch of my choice.

Does anyone have any instructions/diagrams that would explain how to wire the savage hazard switch? Are there any additional components required for the rear led indicators?

[sukhjeevan]

This is the same switch block as used by savage I believe:

http://uk.farnell.com/apem/a0152b/contact-block-dp...

[sukhjeevan]

Does anyone have any instructions/diagrams that would explain how to wire the savage hazard switch?

[sukhjeevan]

Perfect! Thanks

[sukhjeevan]

Don't plan to use the savage switch itself. Just the connection block that it comes with. You can use the connection block and wire any latching switch to it.

[GTRS]

Can anyone tell me where the following hazard warning wires go on the savage hazard warning switch?

Green/Red
Green/Pink
Light Green/Brown
Green/White
Black

[GTRS]

Anyone?

[GTRS]

I'll give that a go and feedback following my smoke test.

Thanks

[GTRS]

On second thoughts....

I'm still midway through sorting out my loom, so we may get a quicker result if you try it first Steve :-)

Edited by GTRS on Monday 21st September 12:52

[GTRS]

Indicator and hazard switches seem to operate ok but the lights don't flash. Instead they remain on or off. It's as if the flasher units are not functioning.

[GTRS]

No lights connected yet, just my Dash2 for testing wiring.