OCD or just Thorough
Discussion
Whilst working on the fuel system of my Ultima I noticed that I like all the washers I use to be the 'right way up'.
Am I suffering from OCD or do others on here do the same thing? If you have to ask if a washer has a 'right way up' then you are not like me!
What started out as a transmission repair seems to have turned into a complete refresh of the back end parts of the car.
I have strengthened the gearbox rear mounting, my chassis top brace, exhaust rear mountings, removed my air-over-oil oil cooler and I am now remodelling the fuel system for better packaging and cooler operation.
Next up is to make some new covers for the coil packs, new heat shields for the side pods to keep header heat away from the fuel system/aircon system. I will also tidy up the sides of my airbox as I have never liked the wrinkles in the heat reflective gold foil.
Then it is on to the second front clip. This one will look a bit more like the Factory one but be interchangeable with my existing one. It will require the removal of two pip pins and two electrical connectors and the whole clip can be removed. Fitting the new one is just as simple!
What have you been doing?
Are you OCD?
Paul
Am I suffering from OCD or do others on here do the same thing? If you have to ask if a washer has a 'right way up' then you are not like me!
What started out as a transmission repair seems to have turned into a complete refresh of the back end parts of the car.
I have strengthened the gearbox rear mounting, my chassis top brace, exhaust rear mountings, removed my air-over-oil oil cooler and I am now remodelling the fuel system for better packaging and cooler operation.
Next up is to make some new covers for the coil packs, new heat shields for the side pods to keep header heat away from the fuel system/aircon system. I will also tidy up the sides of my airbox as I have never liked the wrinkles in the heat reflective gold foil.
Then it is on to the second front clip. This one will look a bit more like the Factory one but be interchangeable with my existing one. It will require the removal of two pip pins and two electrical connectors and the whole clip can be removed. Fitting the new one is just as simple!
What have you been doing?
Are you OCD?
Paul
Gassing Station | Ultima | Top of Page | What's New | My Stuff