Removing Sikaflex (Wurth Bond N Seal)

Removing Sikaflex (Wurth Bond N Seal)

Author
Discussion

huzilulu

Original Poster:

127 posts

113 months

Tuesday 21st July 2015
quotequote all
How the $&%# do you remove sikaflex from.. hair!!!???

WD40 works for skin, but should I just shower with it now?? LOL...

Apparently I got some of it on the back of my hand, and was not aware of it... it then moved to my hair, and has now dried and made a blob of everything... my wife says its a good excuse to get a hair cut!

Just needed to rant... done!

Side pods going in today... I have drilled holes for the AC/heater hoses, LS engine harness, front/rear clam latch cables.. anything else I should do before sticking them in for good?

huzilulu

Original Poster:

127 posts

113 months

Wednesday 22nd July 2015
quotequote all
No, I have not yet tried fitting the fuel tanks - why? Do they need to clear anything from the pod side? The pod sits on this side of the chassis horizontal frame, so I didn't think it could contact the fuel tank in any way...

huzilulu

Original Poster:

127 posts

113 months

Wednesday 22nd July 2015
quotequote all
EDIT: my op should have said luggage pods going in today - not the side pods... My mistake

huzilulu

Original Poster:

127 posts

113 months

Thursday 30th July 2015
quotequote all
That was my solution as well - cut it off...

I only realized I had black goo in my hair a few hours later, by which time it had already set...