Stance Air Cups

[xrtim]

Is anyone using these to raise the height of the suspension to clear road/garage obstructions or any other system. The car is being built at the moment (engine mock up just finishing waste gates routing) but may have a problem getting out of the garage with std ride height

[xrtim]

thanks for the info I will check them out later

[xrtim]

some good ideas there, I aim to go touring with the car when finished so i think a powered system is the way for me but great idea for the air recharge cylinder, hadn't even thought of that many thank for the replys
Tim

[xrtim]

Rscocca said:

I used a kit form a company called RideTech, I can raise and lower front on demand. Raise 3 inches. Only has a small on demand pump, 1 gauge with a needle for each side in gauge. works great.

http://www.ridetech.com/store/shockwaves/

Clears front Uppers if mounted upside down.

I've been driving for about 1200 miles with no issue.

thanks for the information, what specification have you chosen for the install and do you think that they would also fit the rear.
Regards Tim