Another numptie question probably.... Water temp gauge
Discussion
I am sure this is all basics for some of you, but it is advanced for me so bear with me...
My water temperature gauge has stopped working. It is a standard dial and was working fine, then I noticed the needle had just dropped back to zero and now doesn't move. It is an LS2 engine.
Is there anything I should poke or prod or wiggle, and if so, what and where is it? Or anything more technical I should worry about?
I have tried tapping the front of the gauge to see if that helped because sometimes when I am flying a plane and the instruments go wonky it can sort things out, but no such luck in this case
I (sometimes) hate cars!!!
My water temperature gauge has stopped working. It is a standard dial and was working fine, then I noticed the needle had just dropped back to zero and now doesn't move. It is an LS2 engine.
Is there anything I should poke or prod or wiggle, and if so, what and where is it? Or anything more technical I should worry about?
I have tried tapping the front of the gauge to see if that helped because sometimes when I am flying a plane and the instruments go wonky it can sort things out, but no such luck in this case
I (sometimes) hate cars!!!
Gassing Station | Ultima | Top of Page | What's New | My Stuff