kunifer cupro-nickel fuel lines
Discussion
just installing a 10mm o/d kunifer fuel line (flow to injected engine, so about 4 bar max) and not having much luck with flaring it (the flaring tool seems to hold the pipe well, so well that it crushes it quite a bit), but the resulting flare doesn't seem large enough. On the same line, i have some Swagelock stainless steel twin olive compression-type connectors, but i am not sure these will stay tight/leak-free (as the kunifer is comparatively soft, will the fitting loosen over time?).
So, any tips on flaring....and anyone successfully using compression fittings on kunifer?
So, any tips on flaring....and anyone successfully using compression fittings on kunifer?
Gassing Station | Home Mechanics | Top of Page | What's New | My Stuff