Noble newbi

[marc3152]

Hi everybody

I've finally decided after years of lusting to take the plunge and get myself on of these incredible machines.
I have seen one that I like the look of ( http://www.gilescooperautomotive.co.uk/noble-m12-g... )
and it seems to have all the right bits but I would be grateful If anybody has any information on it. Reg M12 AGM

Many thanks

[marc3152]

Thanks. I love the look of the car and I'm hoping the previus owners that did all the mods are still about so I can pick
their brains about the car

[marc3152]

And I really should learn to spell previous

[marc3152]

Thanks Neil. I've emailed the last owner who said it was a good car but ran a bit rough for the first ten mins. ( I'm guessing that's not unusual ? ). Was hoping to get hold of the guy that did the mods. I think he really went though the mill with this car so should know it inside out

[marc3152]

Hi mgbond

It has a MBE ECU with a track and road map at 1 bar boost

[marc3152]

This what it's had in the last 5000 odd miles.

NEW GARRETT GT2860RS BALL BEARING TURBO’S
TRACKN’ROAD MAP TO MBE ECU AT I BAR BOOST
373 BHP@ 7059 RPM / 341 LB FT TORQUE @ 4720 RPM (DYNO GRAPHS)
NEW HAYWARD and SCOTT S/STEEL EXHAUST and MANIFOLDS
NEW PRO ALLOY RADIATOR / INTERCOOLER / BREATHER KIT/ HEADER TANK and HARD PIPE KIT.
REBUILT SHOT PEENED GEARBOX with MUSHROOM BEARINGS
NEW QUAIFE LSD
NEW AP CLUTCH and SLAVE CYLINDER
NEW DRILLED FRONT DISCS with BELLS / PADS
NEW MOCAL GEARBOX COOLER PUMP
NEW FORGE 34mm BLOW OFF VALVE
NEW BOSCH 044 FUEL PUMP + WIRING MOD
OHLIN SINGLE WAY ADJ. DAMPERS
TWO NEW ITG AIR FILTERS
NEW POWER STEERING PUMP
CAM BELT and TENSIONER
NEW TOP / BOTTOM BALL JOINTS / T ROD ENDS
FOUR WHEEL ALIGNMENT
NEW WHEEL BEARINGS
NEW ENGINE MOUNTS
NEW HIGH ENERGY LEADS and PLUGS
NEW REVERIE CARBON F/SPLITTER / 5 ELEMENT REAR DIFFUSER / WING END PLATES / DOOR HANDLES / DOOR MIRRORS and TOWING EYES.
NEW ROSSION STYLE REAR LIGHTS / CLEAR INDICATORS
HIGH LEVEL BRAKE LIGHT
4 REFURBISHED 10 SPOKE ALLOY WHEELS

[marc3152]

Lousy bit of parking!!

[marc3152]

I think they mean the ancillary belt but that's why I'm trying to get as much info as I can
but unfortunately I can't get hold of the guy that did most of the work.

It's up for 30.

[marc3152]

I thought 373 BHP@ 7059 RPM / 341 LB FT TORQUE @ 4720 RPM sounded
OK but I.m a newbie. Does it not depend on the map?