Metro 6R4

[member8888]

Does anyone do a 6R4 replica that can cut the mustard. A repro that looks like and acts like the real thing?

[member8888]

Thanks

[member8888]

Need one, badly.

[member8888]

I've got access to chassis now, a carbonfibre/aluminium extrusion tub currently being developed by a friend of mine. The idea is that I'll buy a metro and add on the 6r4 body panels which can be got hold of quite reasonably, then mould it in two main sections. Front clam shell and main body shell including front bulkhead. All of this will then sit like a remote control car body onto the chassis. This would offer 6rf styling and straightline performance with limited investment. The engine would be transverse and drive the rear wheels only. Possibly duratec. If anyone else is could see themselves driving around in the above I'd be interested as this would spread the cost and speed up the process.

[member8888]

Do such panels exist and if so where?

[member8888]

Ferg,

Was your 6R4 bought for rally or road? Why did you sell it? Can I use your moulds for a small fee to lay up a set for myself?

[member8888]

Thanks ferg,

Do you think a 2wd 6rf would be a let down, perhaps even dangerous to drive with such a short wheel base?

[member8888]

Thanks again for that, I have come across this car on other sites and it looks very impressive. I am begining to realise just how high maintenance the real thing is. The good news though is that I've just bought some 6R4 wings and tailgate and a 40,000 mile 1989 Metro with MOT and Tax. Total cost was £172. I'll have the wings on it before the weeks out. This will no doubt give me plenty of food for thought and hopefully a really daft looking cheap commuter for a few months.