swirlpot 3000s

[plasticpig72]

i have just found a very small leak on the swirlpot. It's around the small pipe that goes to the crossflow rad.
I Wonder if it's Worth getting it fixed as it looks like the original swirlpot.
I think it's best to buy a new one in stainless or alloy.
The last thing i want to do is take a risk then have the engine overheat because of a leak.
So what's you ideas chaps, fix it or bite the bullet and buy a nice new stainless swirlpot with lots of bling
Alan

[plasticpig72]

many thanks Adrian,
well explained and thanks for your help and support
Alan

[plasticpig72]

great idea Chris, i'll look at that for a quick fix.
Alan

Edited by plasticpig72 on Tuesday 17th February 18:07

[plasticpig72]

i have just ordered an alloy swirlpot from DG.
It will have 2 extra tapped bosses, 1 for the temp sender to temp gauge and 1 for temp senser to cooling fans.
I think i will fit a senser that cuts in at 87°C and off at 82°C

Alan

[plasticpig72]

this will be in the swirlpot, which means the water in the rad is 87°C.
I could fit one to cut in at 107°C off 97°C which for me is too hot.
Maybe i will keep the adjustable sensor bulb and fit in swirlpot with an adapter
Alan

Edited by plasticpig72 on Friday 27th February 16:01

[plasticpig72]

I see what you mean.
When i receive the alloy Swirlpot i will fit it and just fit blanks.
There is already a working system with a sensor bulb Inside the return hose from rad.
It works correctly and is adjustable with led warning light + override switch.
I will do a check with my IR Thermometer after a run .
thanks for comments
Alan

[plasticpig72]

just recieved the Alloy Swirlpot from DG and i can say it's fantastic.
Lots of bling and is a nice job.
Alan

Edited by plasticpig72 on Friday 20th March 15:41