Discussion
Rover Tuscan ,original dry sump pan, original pump . I have a 72 square tooth 19mm wide oil pump belt I need to replace. Having no luck finding it, as my belt has no markings on it. My local factors are stumped at the moment. Does any one know a part number for this length belt please.
ctsdave said:
As a start Id guess at a 275L075 wpuld be a good starting point. However, if you give me number of teeth of each pulley wheel and distance betwen pulley centres I can work it out for you.
Morning Dave,I don't have the engine pulley at the moment as I am having a new engine built for next year and it has gone with the crank and damper to be balanced . I will measure all the dimension's and post them up later from the belt see if that helps . I take it pitch is between the teeth ? I can't see it being the part number you suggest as the L075 depicts it as three quarter of an inch wide and I know mine is 20mm ?
If I under stand you Paul the pitch is the distance between teeth ?
Hi Dave
Who works in inches any way LOL I have all the measurements you need I think 27inch long, pitch 0.355
(centre of tooth to centre of tooth), width 0.75, thick 0.075.
Chanty,
Thanks for that link spot on mate, although that part number does not relate to the one Dave Stewart's on about or am I been thick. I will get that one if consensus says to push the "buy it now" button.
Who works in inches any way LOL I have all the measurements you need I think 27inch long, pitch 0.355
(centre of tooth to centre of tooth), width 0.75, thick 0.075.
Chanty,
Thanks for that link spot on mate, although that part number does not relate to the one Dave Stewart's on about or am I been thick. I will get that one if consensus says to push the "buy it now" button.
Gassing Station | General Motorsport | Top of Page | What's New | My Stuff