Wiring Problem

[Jon12345]

Opinions please, nearly had an issue the other day with the big fuse melting. I stripped the fuse and associated wiring out
The wiring, connectors and ring terminals are shot as is the conduit protection. What I plan do is make a direct replacement which is a better quality and more aesthetically pleasing. I have also been looking at the rest of the wiring in the engine bay which to be fair looks abit poor quality and also provides very little heat protection. I would like opinions on making a replacement engine loom with a multi point connector on the bulk head, a bit like this
I thought it may tidy the engine bay up a bit and provide more reliability as I think most of the wiring is chaffing somewhere along the engine bay

[Jon12345]

The components have just arrived for then starter/alternator wiring so will post up this week once iv made up the prototype wiring. I am willing to make some up if all goes well

Edited by Jon12345 on Wednesday 16th July 20:22

[Jon12345]

Completed what you think

[Jon12345]

[Jon12345]

[Jon12345]

[Jon12345]

[Jon12345]

[Jon12345]

Glue filled heat shrink used to seal either end of the cables, soldered ring connectors for better connection and braided polyester tubing for protection against heat and abrasion.