wiper motor problem stays and question about wiper ECU
Discussion
My last wiper motor completely burnt out. Even the connector to the wiper motor got hot. The fuse on my car is on nr. 16 on the fusebox. Do not know if this is right one according to the wiring diagram. It had been burnt in the past and a repair had been made to the fusebox. A new wipermotor is now fitted. I changed the connector to the wiper motor, because i thought this was the reason my fuse burnt when i tried to engage the wipermotor with ignition on. I went down to the wiper ecu. Saw that wiring has been hot there too. What can I do to be sure the ecu is ok? I opened it and it didn't look burnt.....
My old wiper motor burnt out. It also made my fuse collapse, but i didn't know. I then put the new motor in. I pushed the button on the steering wheel, but nothing happened. Checked the fuses and saw that the fuse was broken. P
Ut a new one in. Ignition on. Still ok. Pushed the button again and immediately the fuse burnt. At first i thought the connector on the wiper motor was damaged, so ordered a new one. It was still the same. So, with ognition on the fuse doesn't burn. As soon as i try thr button the fuse blows. It i put 12 volt on the pin which comes from the steering wheel button, for example "speed 1-function" I should measure 12 volt on the "speed 1-wire" to the wiper motor?
Ut a new one in. Ignition on. Still ok. Pushed the button again and immediately the fuse burnt. At first i thought the connector on the wiper motor was damaged, so ordered a new one. It was still the same. So, with ognition on the fuse doesn't burn. As soon as i try thr button the fuse blows. It i put 12 volt on the pin which comes from the steering wheel button, for example "speed 1-function" I should measure 12 volt on the "speed 1-wire" to the wiper motor?
My old wiper motor burnt out. It also made my fuse collapse, but i didn't know. I then put the new motor in. I pushed the button on the steering wheel, but nothing happened. Checked the fuses and saw that the fuse was broken. P
Ut a new one in. Ignition on. Still ok. Pushed the button again and immediately the fuse burnt. At first i thought the connector on the wiper motor was damaged, so ordered a new one. It was still the same. So, with ognition on the fuse doesn't burn. As soon as i try thr button the fuse blows. It i put 12 volt on the pin which comes from the steering wheel button, for example "speed 1-function" I should measure 12 volt on the "speed 1-wire" to the wiper motor?
Ut a new one in. Ignition on. Still ok. Pushed the button again and immediately the fuse burnt. At first i thought the connector on the wiper motor was damaged, so ordered a new one. It was still the same. So, with ognition on the fuse doesn't burn. As soon as i try thr button the fuse blows. It i put 12 volt on the pin which comes from the steering wheel button, for example "speed 1-function" I should measure 12 volt on the "speed 1-wire" to the wiper motor?
Thanks. I am going to try it this way. When I pulled out the wire which drives the 2 drive boxes, no dirt came out. The boxes turned without a problem. Problem with the wiper motor were caused by the motor itself to mu opinion because the spindle that drives the plastic wheel in the gearbox had too much play and therefore it jammed and got very hot. I am going to check section by section.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff