Cerebra door seals

[stickylabels]

My drivers side has come away from the top corner by the A pillar. There seems to be some question
as to whether the later style fits without a lot of phaffing. New ones would be nice, but re-programming
windows/trimming doors seems a bit uneccesary as the old ones appear to be in ok nick otherwise, can
anyone recommend anything to stick it back on at all?

I was thinking tiger seal?

Cheers

Sticky.

[stickylabels]

Cheers for the info Chap. I had a closer look at the pick on Racetechs website and my stuff
looks very similar so may have been done in the past. Had a look at crimping the 'teeth'
closer, but several of them had already burst through the rubber and therefore not gripping
at all.

Spoke with Mark at Racetech and ordered 8m of new as I may as well do both doors and
hopefully I'll get a little less wind noise!

Will post up once on/sworn at (delete as app)

Cheers
Sticky.

[stickylabels]

Right then, whipped off the old seals and pressed in the new ones. The doors do require a slighty firmer push to shut but without actually driving anywhere all seems to be fine! The ones I removed did look pretty similar although much less squishy (technical term). Windows are closing fine too.

They have dropped a years worth of salt onto the roads this week, so a road test will have to wait but I'll post up any changes.

I had a look around for vents in the rear and mine has 2 slots/dips in the leather at the very rear of the parcel shelf which do indeed vent through open moulded channels underneath the rear window so maybe mine always had the updated ones from new?

Anyhoo, hopefully a picture of the slot I'm on about for anyone interested.

Cheers
Sticky.