Rust on chassis
Discussion
Whilst crawling around underneath our R reg Cerb, looking for oil leaks, dead foxes or anything else untoward I mght have picked up on an early morning Sunday run (so the rev-counter does beep at 6800!), I noticed that the mechanical bits look OK, but there are a few patches where the coating has lifted off the chassis tubes in strips of about two inches by one inch. Looks like 100% iron oxide underneath. This may be one step beyond waxoyl
Has anyone had their chassis re-coated, and who was it done by?
Or is it a more economical strategy to leave it & sell on/replace chassis eventually?
Has anyone had their chassis re-coated, and who was it done by?
Or is it a more economical strategy to leave it & sell on/replace chassis eventually?
Gassing Station | Cerbera | Top of Page | What's New | My Stuff