Splicing Into Existing Loom

[R500POP]

I'm needing to splice into some existing wires on the loom of the mirth-mobile to effictively make a 'Y' from the 12v outlet to power a hard wired phone charger, I hate Scotchlocks with a passion, so I was going to use some inline splice joints http://www.vehicle-wiring-products.eu/VWP-onlinest... strip the insulation off, crimp & solder the required wires in, then apply heatshrink to the outside.

I was wondering if there is a more elegant solution that I hadn't come across?

Edited by R500POP on Wednesday 14th September 11:14

[R500POP]

So basically like I'm planniong to do, but they don't have the solder.

[R500POP]

stevieturbo said:

A proper crimp does need or want solder.

But what harm would it do?