OEM 7mm Lash Caps
Discussion
Does anyone know if there is an OEM that uses 7mm stem diameter valve lash cap where they can be ordered by size, something like 0.05mm increments?
Getting my own ground to size is a little tedious and it would be easier to have a stock available.
Thanks for the help.
Steve
Getting my own ground to size is a little tedious and it would be easier to have a stock available.
Thanks for the help.
Steve
Edited by stevesingo on Monday 16th February 14:14
Evoluzione said:
Do you know what skirt length you need? I carry a few for my own use if you're ever desperate, but I tend to have them with shorter skirts for my use.
There is a supplier in East Mids somewhere, they carry blanks or will grind to whatever you need, if you want their number I can dig it out over the next few days.
I forget the skirt length, I'll have to measure. I was hoping there was an OEM that produces them in 0.05 increments.There is a supplier in East Mids somewhere, they carry blanks or will grind to whatever you need, if you want their number I can dig it out over the next few days.
What sort of depth can you grind off blanks without losing hardness?
I think my problem is that the Arrow lash caps I have been using are 5mm thick, unground. In order to get to my desired 4mm and 3.8mm region I am grinding off too much material and therefore losing the hardness. This is why I believe I get increased gaps after only a short period.
The reason I was looking for EOM in 0.05mm increments is that the OEM lash caps will be hardened at the specified size.
The Arrow lash caps have 2.4mm depth.
http://www.arrowprecision.com/shims/171-top-hat-ty...
The reason I was looking for EOM in 0.05mm increments is that the OEM lash caps will be hardened at the specified size.
The Arrow lash caps have 2.4mm depth.
http://www.arrowprecision.com/shims/171-top-hat-ty...
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff