ABS sensor ring 60mm
Discussion
I want to use an ABS ring for an application other than ABS. Ideally the ring would be around 60mm diameter with as many teeth as possible. It seems there are two types, one is simply a ferrous toothed ring and the other is effectively a round multi pole magnet. Ideally I would prefer the multi pole magnet type but could use either.
The problem is the suppliers ask what car the part is for but obviously I don’t know that. Can anyone suggest a vehicle which has an ABS ring of around 60mm. All the ones I have obtained so far are closer to 75 which doesn’t fit my project.
Thanks
The problem is the suppliers ask what car the part is for but obviously I don’t know that. Can anyone suggest a vehicle which has an ABS ring of around 60mm. All the ones I have obtained so far are closer to 75 which doesn’t fit my project.
Thanks
Thank you for that link, it seems a Mitsubishi Gallant one is 65.9 which will just fit in the space have. It is still not ideal as it only leaves a small clearance but should just squeeze in. I did investigate having them laser cut but the cost is too high even at 1000 off.
As you say it needs something with small drive shafts so I was thinking Smart car or something small and French.
As you say it needs something with small drive shafts so I was thinking Smart car or something small and French.
Thanks for the replies.
If required we will get some laser profiled but would prefer to use a standard part already treated against the environment.
I would ideally like 40 or 50 teeth but could live with a few less, it is going on a 10mm shaft so provided the id is more than 10mm that is fine, we will make a bush for it to press on to.
We have some from J&R, the quality and price is spot on but they don't list the three that I have identified as a possibility to fit the space. Being; Ford Ranger, Daewoo Musso and Jeep Grand Cherokee. The OD has to be less than 70mm. Astra would just about squeeze in but doesn’t have enough teeth.
If required we will get some laser profiled but would prefer to use a standard part already treated against the environment.
I would ideally like 40 or 50 teeth but could live with a few less, it is going on a 10mm shaft so provided the id is more than 10mm that is fine, we will make a bush for it to press on to.
We have some from J&R, the quality and price is spot on but they don't list the three that I have identified as a possibility to fit the space. Being; Ford Ranger, Daewoo Musso and Jeep Grand Cherokee. The OD has to be less than 70mm. Astra would just about squeeze in but doesn’t have enough teeth.
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff