Oil Pressure Sensor..
Discussion
I have to replace my oil pressure sensor as the gauge is all over the place, then works fine for a while. Being as its at the back of the block do I have to take the manifold off to replace it (have read up on the ls1 forum)and was thinking of fitting one of these kits, has anyone else done so...........
www.ls1.com/forums/f60/diy-oil-pressure-sensor-replacement-relocation-136780/
this is the kit.........
www.dpecorvettes.com/gpage7.html
www.ls1.com/forums/f60/diy-oil-pressure-sensor-replacement-relocation-136780/
this is the kit.........
www.dpecorvettes.com/gpage7.html
Edited by donk r8 on Tuesday 10th April 09:09
From your profile you have a monaro, not a corvette?
Then I may have some good news as I have a 2006 VXR Monaro and I replaced the oil pressure sender with a socket set in about 10 mins as its located at the back of the engine but not covered by anything, just a bit of a pain to access between pipes and wires.
I also got a Brass version rather than Ally as they apparently last longer
Hope this helps
Then I may have some good news as I have a 2006 VXR Monaro and I replaced the oil pressure sender with a socket set in about 10 mins as its located at the back of the engine but not covered by anything, just a bit of a pain to access between pipes and wires.
I also got a Brass version rather than Ally as they apparently last longer
Hope this helps
YME said:
From your profile you have a monaro, not a corvette?
Then I may have some good news as I have a 2006 VXR Monaro and I replaced the oil pressure sender with a socket set in about 10 mins as its located at the back of the engine but not covered by anything, just a bit of a pain to access between pipes and wires.
I also got a Brass version rather than Ally as they apparently last longer
Hope this helps
Just like YME says Donk You will get sore nuckles though Then I may have some good news as I have a 2006 VXR Monaro and I replaced the oil pressure sender with a socket set in about 10 mins as its located at the back of the engine but not covered by anything, just a bit of a pain to access between pipes and wires.
I also got a Brass version rather than Ally as they apparently last longer
Hope this helps
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff