Datatool S4 fault won't disarm

[mr2haz]

My 2007 zx6r is fitted with a Datatool s4 and today the remotes will not disarm the system.

The bike is not in regular use and recently the alarm fob range has been reduced. The last two times I have had to turn on the ignition before the remote will disarm. I have also noticed recently the indicators do not flash when the system auto arms, which I am sure it used to.

Today I took the bike out of the garage disarming the system after turning on the ignition. I started the bike and moved it round to a location suitable to wash the bike and ever since then the alarm fob will not do anything. I have two fobs, both do not function including fitting a replacement battery.

I can start the bike using the pin override but this is not a practical option and neither is ripping the system out. The system confirms two remotes are programmed.

So can it be fixed?

[mr2haz]

I can confirm this is not the issue as I went over to my parents house six miles away where I had the same problems.

[mr2haz]

I set about ripping the alarm out over the weekend but upon locating the unit I discovered the remote works when operated within 10cm of the unit.