Protecting the outriggers
Discussion
Recent purchased Chimaera has the original outriggers which although solid have quite a bit of surface rust on them.
Someone in the past (probably the same guy who bypassed the fan switch) has put underseal on what I suspect is the visible half. I had thought of running emery paper around over the top to clean of the rust then a coat of something but there just isn't the clearance for a brush.
So I need a way of coating them sufficiently around all 360 degrees, and probably a spray.
I would even consider fully filling the upturned U of the floor with wax if that'll help.
Short of lifting the body, what has been found to be the best method of protection.
Thanks
Someone in the past (probably the same guy who bypassed the fan switch) has put underseal on what I suspect is the visible half. I had thought of running emery paper around over the top to clean of the rust then a coat of something but there just isn't the clearance for a brush.
So I need a way of coating them sufficiently around all 360 degrees, and probably a spray.
I would even consider fully filling the upturned U of the floor with wax if that'll help.
Short of lifting the body, what has been found to be the best method of protection.
Thanks
Gassing Station | Chimaera | Top of Page | What's New | My Stuff