New roll cage getting fitted
Discussion
The cage is made from chromoly and being made to MSA spec with the design and details having been approved by the head engineer at MSA.
It looks a mess at the moment but I am sure it will come together nicely.
The cage should be finished this weekend and then the car goes next door to have all the fibreglass work sorted.
It looks a mess at the moment but I am sure it will come together nicely.
The cage should be finished this weekend and then the car goes next door to have all the fibreglass work sorted.
jesfirth said:
Are you fitting diagonals and rear belt support bar across the back
It will just be a typical 6 point with a door bar. The door bar has to pass between my shoulder and elbow but we are going to have it drop as low as we can as soon as possible. Basically so I can squeeze my lard ass in there.Anchor points will be added for the harness. I am not sure if there will be a bar across the back of the seats yet.
77racing said:
will you be able to get cage out to paint it ?
It's going to be welded in Pel.David will protect the welded areas to the chassis before sending the car next door to have the fibreglass repaired.
We decided last night to fit a swing out bar in the doorway as access is going to be tight as you can see here.
Edited by DangerousDerek on Wednesday 27th January 06:23
Gassing Station | Chimaera | Top of Page | What's New | My Stuff