Emerald K3 ECU...Is it suitable for Rv8.??
Discussion
spitfire4v8 said:
The latest ecu is the K6 but yes the earlier K3 is virtually the same .. it's based on the older hardware but with most of the functionality of the K6 (moveable load and rpm sites, target AFR table, self learning 3 map facility etc etc). The only thing you really lose out on with a K3 over the K6 is the ability to control the std 4 wire stepper motor .. so either go without it, or substitute in another eg bosch 2 wire unit instead. Fitted loads of emeralds of all variations over the past 15 years.
Thanks for that...Which bosch unit will fit?Gassing Station | Chimaera | Top of Page | What's New | My Stuff