oil pressure new isspro sender fitted
Discussion
Hi,just in from work, I fit the new unit the same as Chimpongas as I had read an earlier topic about fitting so I knew about lifting engine a little to give room for longer sensor and it was easy to fit .I used the original wire to gauge .The earth wire I put on is a bit heavier than the gauge wire would this affect the readings
Hi ClassicChimeara. I have not had time to look at mine due to work but I am going to try new cables this weekend .I got the Isspro sender as I hade read on the forum that they were more accurate I can take my sender to work to get it checked as I contacted the supplier and he said if its ok it should show 240 ohms resistance .a sparky will check this for me. I will let you know results after I change wires
Gassing Station | Chimaera | Top of Page | What's New | My Stuff