Alternative Part Numbers

[chassis 33]

I know this has been done a couple of times, parts on Steve's body off thread and there is the list on the Griffpages site, however just for some extra information...

Track rod end - Mk2 Escort/Cortina Mk 3/4/5 - £5.72 exc. VAT
Motaquip #VTR151
Lockheed/Delphi #TA687 **or possibly not, see Meeko's post below**
Q/H #QR1384S
Unipart #GSJ388
Federal-Mogul (Moog) #FD-ES-0334

Upper Ball Joint - Saab 900 - £20.75 exc. VAT
Motaquip #VSJ388
Q/H #QSJ1004S

Regards
Iain
(mods any chance of a sticky?)

General Disclaimer...all the information posted by folks is given in good faith, check, double check and check again that the part you order/buy is the same as the the part you need.


>> Edited by chassis 33 on Wednesday 1st February 13:42

[chassis 33]

This is an useful link if you know the part number you're trying to replace
www.intermotor.co.uk/prod_cat.asp

ECU Coolant Temperature Sensor

Lucas SNB802 can be replaced by
Intermotor 55128
Facet 73200
Land Rover ETC8496
Lucas 73355A
Lucas 8TT
Lucas SNB802
Webcon WTS163
Jaguar EAC3927 "SENSOR, COOLANT TEMPERATURE, FOR THE FUEL INJECTION SYSTEM. FITS 1980-1992 XJ6 AND 1980-1988 XJS from http://jagbits.com/seriesiiiengine.html"



Apparently there are two Unipart equivalents, the difference is the thread size, if memory serves you want the smaller of the two thread sizes.

[chassis 33]

More trawling through the PH back catlogue has uncovered these...

Headlight Part numbers

The reflector is a Bosch 1 305 314 930.

The lens is Bosch 1 305 604 027

from www.pistonheads.com/gassing/topic.asp?t=217543&f=8&h=0

Regards
Iain

[chassis 33]

Here it is...


BB has put it in a table format here www.thegriffithpages.com/content/view/79/83/ however there are a couple of typos...must, let BB know.

I can send you a Excel sheet of every nut and bolt on the chassis giving thread (mostly 7/16" UNF), length, torque and spanner sizes (although they may vary).

Axe, alternative parts on the Chimaera pages would be useful. the griff pages have got one which I'm sure BB will let you plagiarise in return for a link and information going the other way too.

Regards
Iain

[chassis 33]

There's an update bolt/torque list here www.thegriffithpages.com/content/view/97/83/ with the bolt sizes added for reference and hopefullt to speed the process up for you.

Regards
Iain

[Chassis 33]

I don't know of any equivalent part number for the swirl pot bung, however there are two options, I believe the thread is 1/2" BSP so any plumbing supplies should be able to sell you a 1/2" BSP plug, or Steve Heath does a nice replacement setup https://delta.securesslhost.net/~shenglt/catalog/p...

Thermostat, I've always used the generic Rover/Landrover thermostat without problems for example those show here http://www.rimmerbros.co.uk/rimmer/rover/v8engine/... however some say thee is a particular type you should use, not sure which it is though.

Regards
Iain