Audi A3 reversing sensor removal.
Discussion
Anyone know how they detach from the bumper? Anyone removed one?
My 2007 Audi A3 parking sensors are not working, just giving a long beep. I know which sensor is not working as its not clicking like the others. I have an S-line which has a slightly different bumper but if I remove the bottom screws I can just about get my hand up and have checked the connector tight, I also know I can get a new sensor for about £12 on e-bay.
What I can't work out from any forums is how it clips to the bumper. Pictures show a small tab on the side, not sure if it twists slightly to release or if there is something else.
Picture: http://www.bacho.rbo.bg/NS/Items/P6/1.jpg
If anyone knows it would be appreciated. Thanks. Nick.
Update if anyone else has a problem:
Really easy job in the end, bought a brand new sensor from e-bay for £12, a thin coat of primer, two coats of paint (I already had) and a clear lacquer coat. Left to dry for 24hrs.
Knew which one was not working as was not 'clicking'. Unscrew bottom two screws under the rear valence, three around the wheel arch. On the s-line you can get your hand up to them, unclip them out. New one in. Matches perfect and works fine. Five screws back in.
Took about 20 minutes painting, 15 minutes to fit.
Really easy job in the end, bought a brand new sensor from e-bay for £12, a thin coat of primer, two coats of paint (I already had) and a clear lacquer coat. Left to dry for 24hrs.
Knew which one was not working as was not 'clicking'. Unscrew bottom two screws under the rear valence, three around the wheel arch. On the s-line you can get your hand up to them, unclip them out. New one in. Matches perfect and works fine. Five screws back in.
Took about 20 minutes painting, 15 minutes to fit.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff