Electric Mirror Switch
Discussion
Thanks guys, I will check the wiring connections under the dash. Though now thinking it could be the relay! The symptoms are that with the switch in the RH mirror position no matter what position you operate the joystick the mirror will only go left and right. When set in the LH mirror position LH mirror only goes up and down? Strange one. Wanted to sound people out before stripping out the door and switches etc. Any further thoughts?
waggy said:
Pete,, just checked the bible and found on the 4.0 and 4.3 griffs the mirror control box is in the door , because of water ingress they decided on the 5.0 to move the box next to steering collumn. Looks like a door card off ,, good luck removing it, need small arm to reach nuts at back off door,, alex
Cheers Alex, will try and get the door card off over the bank holiday weekend. PeteTVRVixenV8 said:
Pete, any news? What was the cause of your problem? Have nearly the same issue in my 430 and i'm sure it's caused by faulty switch.
Cheers
Axel
Hi Axel, no resolution yet! Had a look again on Saturday but did not have the patience at the time to take the door card off. I am convinced its the large changeover switch, as it looks really dilapedated and loose in operation. I would like to change it, just to eliminate it, but cannot identify where the switch originated from! Have you any ideas? PeteCheers
Axel
waggy said:
Pete , could it be this , off a Rover SD1
http://www.rimmerbros.co.uk/Item--i-BRC9149
also found same switch off Classic Range Rover, Rover Code = PRC5751.
cheaper on Ebay, item number - 290922264982
Alex Red
Hi Alex, thanks for the info above. Unfortunately not the same switch! Min has a separate toggle (like the one on Range Rover) but the changeover switch is a lot larger and has about 8 spade terminals! I have tried the Vauxhall variants to no success, even Citroen (whose mirrors they are) do not have the same switches. So stil looking. Regards, Petehttp://www.rimmerbros.co.uk/Item--i-BRC9149
also found same switch off Classic Range Rover, Rover Code = PRC5751.
cheaper on Ebay, item number - 290922264982
Alex Red
Edited by waggy on Tuesday 4th June 09:45
Edited by waggy on Tuesday 4th June 10:01
Cheers Spend very helpful. I don't think there is a relay, believe the large changeover switch changes the function from left to right! Anyway here is a pic of the offending item:
Just to recap the fault: In R/H operation right mirror only goes left and right no up down, L/H operation left mirror only goes up and down (both of those operations irrespective of joystick position)
All the best, Pete
Just to recap the fault: In R/H operation right mirror only goes left and right no up down, L/H operation left mirror only goes up and down (both of those operations irrespective of joystick position)
All the best, Pete
spend said:
You will have a relay...
The 'changeover switch' directs operation to the left or right mirror
The relay is imperative to switch the common wire +/- depending on what the other wire to each motor is being sent. If you look at my diag the citroen mirror just has 2 motors the first connected to BR & RU wires, the second to RU & ltG wires. One motor works up - down which is controlled by sending +&-'ve or -&+'ve down the wires, the second works left and right in the same way. The joystick manages the swapping of polarity on the BR & ltG wires, but relies on the relay to switch the polarity on the RU wire.
The relay is very tricky to get at on the 430 but I would say with 95% certainty that it is your problem.
Cheers Spend I shall look for the relay. Will it be in the door or elsewhere? PeteThe 'changeover switch' directs operation to the left or right mirror
The relay is imperative to switch the common wire +/- depending on what the other wire to each motor is being sent. If you look at my diag the citroen mirror just has 2 motors the first connected to BR & RU wires, the second to RU & ltG wires. One motor works up - down which is controlled by sending +&-'ve or -&+'ve down the wires, the second works left and right in the same way. The joystick manages the swapping of polarity on the BR & ltG wires, but relies on the relay to switch the polarity on the RU wire.
The relay is very tricky to get at on the 430 but I would say with 95% certainty that it is your problem.
Griffer said:
PeteGriff, if you are still looking for the mirror changeover switch RaceTech have them listed on their site, part no. M0106 @£10.37+VAT
Hi Griffer, how uncanny! I have just ordered some rubber door finishers and noticed they did the switches, have now ordered one. Thanks mate. PeteGassing Station | Griffith | Top of Page | What's New | My Stuff