Intermittant loss of power
Discussion
I have been suffering on and off for a while now with a total loss of power that occurs for approx. 0.5s to 2s, it is like someone turns off the fuel. At the moment it occurs during warm-up but previously it has occurred when hot (it is a long story and trying not to write was and peace!)
The two relays have been swapped (fuel pump and ?) and then the throttle pot and each time the symptoms have changed or stopped only to return.
I have plugged it into RoverGauge and the log shows that the throttle pot value becomes zero (when closed throttle is ~1.1 so this is definitely a problem) but at the same time the "idlebypass" opens very rapidly.
I'm assuming that the "idlebypass" in RoverGauge is a command to the stepper motor as AFAIK there is no feedback from the stepper motor. I'd also assume that there is no reason for this to react to the throttle pot so there is something larger going on than a dodgy throttle pot. I.e. some sort of EMC or power related issue.
The car has had an engine replacement recently, could this be caused by a bad earth connection? I.e. earth voltage rises and causes all the sensors to mis-read? I had no such problem before the engine work...
Rob
The two relays have been swapped (fuel pump and ?) and then the throttle pot and each time the symptoms have changed or stopped only to return.
I have plugged it into RoverGauge and the log shows that the throttle pot value becomes zero (when closed throttle is ~1.1 so this is definitely a problem) but at the same time the "idlebypass" opens very rapidly.
I'm assuming that the "idlebypass" in RoverGauge is a command to the stepper motor as AFAIK there is no feedback from the stepper motor. I'd also assume that there is no reason for this to react to the throttle pot so there is something larger going on than a dodgy throttle pot. I.e. some sort of EMC or power related issue.
The car has had an engine replacement recently, could this be caused by a bad earth connection? I.e. earth voltage rises and causes all the sensors to mis-read? I had no such problem before the engine work...
Rob
Already replaced the TP and the problem only occurs during warm up. Also, could the TP going to zero explain the sudden rise in the idlebypass? I'm assuming that the idlebypass is independent of the throttle pot but if I'm wrong then it could well be a second duff TP, just seems unliklely.
Rob
P.S. during the event the RoverGauge shows no change in the injector duration. This seems to contradict the other results. I'm guessing that this is duration is from the map but the error condition caused by the throttle pot means that this is overridden, I.e. despite the map the injectors are actually off, causing the lack of power. Bit of a guess though.
Rob
P.S. during the event the RoverGauge shows no change in the injector duration. This seems to contradict the other results. I'm guessing that this is duration is from the map but the error condition caused by the throttle pot means that this is overridden, I.e. despite the map the injectors are actually off, causing the lack of power. Bit of a guess though.
Gassing Station | Griffith | Top of Page | What's New | My Stuff