Cutting Out on Acceleration
Discussion
Hi guys,
I am new to Griffith ownership and am over the moon to have this awesome car. What a joy!
I am, however, experiencing a teething problem. Car is a 1996 500hc
In the last month, the car has had the Coil replaced.
Last week drove for about 30-40 mins, not pushing it hard, but enjoying it. I then turned right at a small island, and accelerated in 3rd up a moderate hill up to 40mph. Engine then cut out and I nursed it into a side road. Couldn't restart it. It wanted to turnover, but just having caught, it would cut out again. Tried about 3 times.
Left it for 5 hours, it had obviously cooled down, and it started just fine. Drove home.
I have been out in it twice since for about 15-20 mins or so, and no problems during this short time.
The garage is collecting it next week to investigate, but I wondered if from the symptoms I described, anyone would care to offer their thoughts and suggestions?
Thank you
I am new to Griffith ownership and am over the moon to have this awesome car. What a joy!
I am, however, experiencing a teething problem. Car is a 1996 500hc
In the last month, the car has had the Coil replaced.
Last week drove for about 30-40 mins, not pushing it hard, but enjoying it. I then turned right at a small island, and accelerated in 3rd up a moderate hill up to 40mph. Engine then cut out and I nursed it into a side road. Couldn't restart it. It wanted to turnover, but just having caught, it would cut out again. Tried about 3 times.
Left it for 5 hours, it had obviously cooled down, and it started just fine. Drove home.
I have been out in it twice since for about 15-20 mins or so, and no problems during this short time.
The garage is collecting it next week to investigate, but I wondered if from the symptoms I described, anyone would care to offer their thoughts and suggestions?
Thank you
Gassing Station | Griffith | Top of Page | What's New | My Stuff