clear film on a new pork
Discussion
khushy said:
The film should be pre-cut.
That was a paintshield install, I told the owner at the time not to do it!!You need an install that wraps around the edges of each panel, mine is PS too & the muck that gets stuck on the leading edges is terrible, it does a job but thats as far as it goes
BigGameHunter said:
That was a paintshield install, I told the owner at the time not to do it!!
You need an install that wraps around the edges of each panel, mine is PS too & the muck that gets stuck on the leading edges is terrible, it does a job but thats as far as it goes
Exactly right - ensure all leading edges are wrapped... I explicitly asked for this on my PS and it wasn't done, and now also have crap getting stuck at the ends, doors especially. You need an install that wraps around the edges of each panel, mine is PS too & the muck that gets stuck on the leading edges is terrible, it does a job but thats as far as it goes
khooni said:
looks like venture shield is the recommended product. the question is whether they can provide the service at the dealer or do I have to risk driving there on collection to get it done....?
When I had mine done, I used very low adhesive tape to cover the more likely areas that stone chips affect and drove it up to the installer. Always best to get it done at the installers premises imo - they have all the tools, can better control the environment (dust etc) and, are more likely to take their time on the job and do it right. Gassing Station | Porsche General | Top of Page | What's New | My Stuff