Outrigger steel size/type/source
Discussion
Hi all,
Search is down and I just went back trough every post back to Feb (sure I have seen the details somewhere).
Has anyone kept details of the steel they bought for outrigger replacement?
Looks to be 3mm plate and circa 40mm tube? Also what wall thickness did you go for?
I am planning to fit an internal sleeve at the joins. Again if anyone has diameters handy I would be most appreciative.
Thanks,
Matt
Search is down and I just went back trough every post back to Feb (sure I have seen the details somewhere).
Has anyone kept details of the steel they bought for outrigger replacement?
Looks to be 3mm plate and circa 40mm tube? Also what wall thickness did you go for?
I am planning to fit an internal sleeve at the joins. Again if anyone has diameters handy I would be most appreciative.
Thanks,
Matt
Typical. Missed thr topic resurection on General TVR forum on this very subject yesterday.. here...
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
If you have anything to add please post to the original thread link above.
Thanks,
Matt
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
If you have anything to add please post to the original thread link above.
Thanks,
Matt
Typical. Missed thr topic resurection on General TVR forum on this very subject yesterday.. here...
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
If you have anything to add please post to the original thread link above.
Thanks,
Matt
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
If you have anything to add please post to the original thread link above.
Thanks,
Matt
Gassing Station | Chimaera | Top of Page | What's New | My Stuff