Discussion
Here are some on e-bay at the moment linky
Nothing to do with me, but the price is about normal.
Fitting is pretty straight forward, as others have said just a case of drilling new holes fractionally below your current holes in the rear/lower panel. If you fit them in place on the hoop section and then offer up to the lower panel with the hood up you'll see where you need to drill. Just make sure that you tension the hoop so you get a nice tight fit.
Nothing to do with me, but the price is about normal.
Fitting is pretty straight forward, as others have said just a case of drilling new holes fractionally below your current holes in the rear/lower panel. If you fit them in place on the hoop section and then offer up to the lower panel with the hood up you'll see where you need to drill. Just make sure that you tension the hoop so you get a nice tight fit.
Sandgrounder said:
Hello Gerald-Tvr (Norman isn't it?), Have you replaced them on your S?
I was hoping it was a straight swap. Do you have any details about the re-drilling? ie. is it obvious where to drill, or am I likely to install them incorrectly?
Thanks
Yep thats me I did replace them on Gerald my S2 now moved on, about 1/2" or less BUT it depends on the car each pair of stays were individually fitted at the factory to give the correct tension to the rear hoos section!! TVRs - each is an individual!!I was hoping it was a straight swap. Do you have any details about the re-drilling? ie. is it obvious where to drill, or am I likely to install them incorrectly?
Thanks
Gassing Station | S Series | Top of Page | What's New | My Stuff



