|
F.C.
Original Poster
2,577 posts
78 months
|
Someone on here fabricated an internal door pull that from memory braced from the latching mech to the front of the door, giving a bar to hold to shut the door rather than pulling on the rim of the glass fiber hole,
This may have had a latch pull incorporated into it.
Anyone remember who did it?
|
|
|
ezakimak
1,376 posts
106 months
|
i know i have seen photos of the side intrusion bar that was installed inside the door of a car that was apparently in Australia (presume it was a side impact engineering and registration requirement but can’t confirm). looked like a 50MM OD pipe that ran from hinge to latch. needed the skins separated in order to install....
is that what you are after?
|
|
|
ultimichael
155 posts
125 months
|
Tony, this one?   Michael
|
|
Gassing Station | Ultima | Ultima
What's New | My Stuff | Top of Page
