|
crypto
Original Poster
113 posts
110 months
|
Need a new cat for my Cerb. There is a wide range from 85£ until 400£ on ebay.
What is the quality difference on these parts and what can be recommended ?
Shoud I change the cats (and lambdas) by the pair or is a single one ok too ?
|
|
|
Don1
8,995 posts
77 months
|
Personally the high-flow cats would be on my list. I would replace the pair, and bits around it. But that is just me, and I'm not ace at this!
|
|
|
Basil Brush
3,863 posts
132 months
|
The cheapy ones are ok if you are just going to put them in for an MOT and then remove. I wouldn't run more than a few miles with them though.
|
|
|
crypto
Original Poster
113 posts
110 months
|
Don1 said: Personally the high-flow cats would be on my list. I would replace the pair, and bits around it. But that is just me, and I'm not ace at this! any ideas where I get them ? (or is any above 180£ ok, should have one with certificate) are the original ones high-flow cats ?
|
|
|
Don1
8,995 posts
77 months
|
|
|
RedSpike66
1,971 posts
81 months
|
Don't use the cheap ones - how much is your engine worth ??? You don't want bits of cat being sucked back into cylinders...
|
|
Gassing Station | TVR | Speed Six Engine
What's New | My Stuff | Top of Page
