wtb: Old or broken 993TT Ecu

[sfl993t4]

Just in case anyone has one in the garage or shed that they are not using. You never know...

I need one to make an adaptor loom to help me fit an aftermarket ECU.
I think that it uses an 88 pin connector.
Alternatively if anyone else knows of any other ecu's that use exactly the same connector (unfortunately I don't have the loom here with me to check so would need to be pretty sure.
Steve

[Slippydiff]

I believe the Mk1 996 GT3 is the same item. If you're struggling, speak to Matt at Fearnsport, he may be able to help out. If he can't he'll know someone who can.

[sfl993t4]

Thanks for that, will give him a call in the morning (I don't suppose you have an email address for him)?
best regards
Steve

[Pope]

Speak to Steve at GWR Motorsport - he'll be able to sort any wiring/connector issue you have

01793 527373

http://www.gwrmotorsport.com/

[keep it lit]

Slippydiff said:

I believe the Mk1 996 GT3 is the same item. If you're struggling, speak to Matt at Fearnsport, he may be able to help out. If he can't he'll know someone who can.

early boxster also same..

[fioran0]

I'm being dense but is it the ecu you need (for the connector) or the loom with the connector? I should have both if its the same as mk1 996. Message me and ill look out what I have to see if its what you need.

[sfl993t4]

Hi, yes it's the ecu I'm after so that I can use its connector / header to connect to the loom (and then make an adaptor for the new ecu)
All help is greatly appreciated
Steve

[phelix]

If all else fails:

http://www.aliexpress.com/store/product/ECU-car-en...

http://motorsportwiringsupply.com/bosch-connector-...

[fioran0]

then i 100% have an ecu for a mk1 996 (motronic 5.2). if this is what you need i will look it out.