996 Turbo how to remove a PCM ll unit
Discussion
Hi
Thanks for Help, but;
I don't know if mine is normal or not but i don't seem to have a horse shoe surround which you are telling me to remove!
I assume it is like a normal size surround like what is around the normal din size stereo? (about 3 or 4mm thick)
I have what i think is a double din size unit with a drinks holder above then the vent.
Do you mean the surround with the switches/vents in?
Thanks in advance
Thanks for Help, but;
I don't know if mine is normal or not but i don't seem to have a horse shoe surround which you are telling me to remove!
I assume it is like a normal size surround like what is around the normal din size stereo? (about 3 or 4mm thick)
I have what i think is a double din size unit with a drinks holder above then the vent.
Do you mean the surround with the switches/vents in?
Thanks in advance
the surround with the switches in pulls of along with strip along top of vents hence the horseshoe type trim... if you get something thin at the bottom edge you can pull it away from the dash but try not to prise off against dash as you'll mark it ..the vents stay in place along with the drinks holder
Hi,
Thanks for advise,
To remove the pcm2 unit i had to remove the horse shoe surround with switches in and then remove the air vent by pulling down the two clips/catches through the vent gaps, this enabled the vent to be removed and thus the pcm2/drinks holder.
You can then part the surround from the unit by pressing in the 4 clips on the side and pulling the unit through.
Thanks for advise,
To remove the pcm2 unit i had to remove the horse shoe surround with switches in and then remove the air vent by pulling down the two clips/catches through the vent gaps, this enabled the vent to be removed and thus the pcm2/drinks holder.
You can then part the surround from the unit by pressing in the 4 clips on the side and pulling the unit through.
Can anyone help!
I have removed the horse shoe trim, I can now see two torx bolts behind the trim at either side of the bottom corners. I can see deeper into the dashboard two torx nuts bolting I to bare, silver metal roughy 2/3rds of the way up the system and two torx bolts either side of the cup holders. Which ones should I be removing, unscrewing please? I have PCM2.
I have removed the horse shoe trim, I can now see two torx bolts behind the trim at either side of the bottom corners. I can see deeper into the dashboard two torx nuts bolting I to bare, silver metal roughy 2/3rds of the way up the system and two torx bolts either side of the cup holders. Which ones should I be removing, unscrewing please? I have PCM2.
Can anyone help!
I have removed the horse shoe trim, I can now see two torx bolts behind the trim at either side of the bottom corners. I can see deeper into the dashboard two torx nuts bolting I to bare, silver metal roughy 2/3rds of the way up the system and two torx bolts either side of the cup holders. Which ones should I be removing, unscrewing please? I have PCM2.
I have removed the horse shoe trim, I can now see two torx bolts behind the trim at either side of the bottom corners. I can see deeper into the dashboard two torx nuts bolting I to bare, silver metal roughy 2/3rds of the way up the system and two torx bolts either side of the cup holders. Which ones should I be removing, unscrewing please? I have PCM2.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff