Heel and toe

[DocSteve]

Hi

Does anyone else struggle to H&T with their 2015+ Mustang. I've got a manual pre-refresh V8 and finding it very hard due to pedal position and over-assisted brakes. I see there's a few aftermarket pedal kits including spacers and wondered if anyone has tried these?

Cheers
Steve

[bridgdav]

Steeda Heel and Toe accelerator pedal.. job done..





Proper heel toe on track generally has a fuller press of the brake pedal, so I find pedal height to be less of an issue. The Steeda plate also raises the accelerator pedal up 1/4 inch too.

[DocSteve]

Thanks - I've just received it although the fitting instructions seem pretty gash. Any tips? I have both bolts and self threading screws come with mine (I just ordered the accelerator pedal)

Cheers
Steve

[bridgdav]

I would remove the whole pedal if I was you.
It is an electrical progressive switch which you should disconnect, then 3 screws from memory.

Put the plate on the plastic pedal and drill through. I used a couple of self tapping screws and some M4 bolts and nuts to secure it. I think it was 2 of each.

You could pack the back of the plate with some washers to lift the pedal surface up further if need be.

Good luck..!!