Undersealing

Author
Discussion

David-1dyf3

Original Poster:

23 posts

97 months

Friday 18th January 2019
quotequote all
Looking for advice on which bilt hamber product for undersealing with, at the moment I've wire wheeled the under side back to clean metal. Then used BH Hydrate 80 for hard to reach areas and on the clean metal that's pitted for good measure.
Next to zinc on top of that just for be thorough with the job.
Then iam looking for advice on my top coat BH epoxy mastic or dynax UC?
I'm leaning more towards the epoxy mastic.



Edited by David-1dyf3 on Friday 18th January 18:17

T-bagger

446 posts

203 months

Friday 18th January 2019
quotequote all
I think you’ve started the right way and I would suggest epoxy mastic next, followed by a decent stone chip e.g. 3M. This is how I went about my E36 M3 underside restoration.