Removing Tail Lights
Discussion
I'm in the process of upgrading my tail lights, but I'm not able to get the tail light pod covers off from inside the rear claim. I have removed the two screws that attach the pod to the clam, but my clam has a Line-X covering...which was sprayed over the tail light pods. I think I'm going to have to cut through the Line-X to remove the pods, but I don't know where to cut. Might anyone have any pictures of the pods that I could use for reference? Thanks!
The housing the lamp is fitted to is one complete entity with only the screw and cable holes connecting front to back.
On that basis I would guess the lamps have been set in a bed of sealant when they were fitted.
To get them out try pushing through the screw holes and see if they will pop out.
Steve
On that basis I would guess the lamps have been set in a bed of sealant when they were fitted.
To get them out try pushing through the screw holes and see if they will pop out.
Steve
emissary said:
I'm in the process of upgrading my tail lights, but I'm not able to get the tail light pod covers off from inside the rear claim. I have removed the two screws that attach the pod to the clam, but my clam has a Line-X covering...which was sprayed over the tail light pods. I think I'm going to have to cut through the Line-X to remove the pods, but I don't know where to cut. Might anyone have any pictures of the pods that I could use for reference? Thanks!
Do you have reversing lights? or are you going to enable the reversing light on the new cluster?Gassing Station | Ultima | Top of Page | What's New | My Stuff