Outdoor room project
Discussion
Hi,
I'm about to move into a new place and I'm looking at one renovation project that wifey and I would like to get done but we have no idea of costs or where to really start with it.
In the image above you can see what is a slightly dated / tired outdoor room that we would like to modernise, we are hoping to remove the existing glass and doors in the areas I have highlighted in red and go for some big glass doors that we can open this space up fully in the summer.
The blue area I have highlighted is some old wooden cladding that I want to get replaced with zinc cladding.
Anyone here have a very rough idea of cost for such a project and if it would be within the scope of needing an architect or not? I don't think there would be much of a big planning process here to go through either.
Any hints or tips on where we should start with such a project would be welcomed!
Cheers
I'm about to move into a new place and I'm looking at one renovation project that wifey and I would like to get done but we have no idea of costs or where to really start with it.
In the image above you can see what is a slightly dated / tired outdoor room that we would like to modernise, we are hoping to remove the existing glass and doors in the areas I have highlighted in red and go for some big glass doors that we can open this space up fully in the summer.
The blue area I have highlighted is some old wooden cladding that I want to get replaced with zinc cladding.
Anyone here have a very rough idea of cost for such a project and if it would be within the scope of needing an architect or not? I don't think there would be much of a big planning process here to go through either.
Any hints or tips on where we should start with such a project would be welcomed!
Cheers
Edited by Oceanic on Thursday 4th May 21:21
hyphen said:
Don't think you will need a architect if just those two things but may be wrong.
You will need a structural engineer to specify the steel beam over the bi-folds though.
Thanks.You will need a structural engineer to specify the steel beam over the bi-folds though.
I'm hoping to involve the least amount of people possible.
Anyone with the most roughest costs..?
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff