14cux rover set up question
Discussion
Hi all
Have a quick question re the 14cux. Fitted 3.9 with lt77 in Mgb gt, been on carb it’s now on injection off RR.
Had it running but wouldn’t idle unless I popped a washer under the idle stop on the plenum, but it warmed up and would restart etc
Anyway, one question is roverguage shows a fault that it’s in rev/drive? I have fitted a 510ohm resistor to ground on the orange and black wire, but still reading it as an auto.
Secondly is the inability to start on tickover due to 3% throttle position (without washer) and my maf voltage 1:25v which is low?
Thoughts greatfully recieved
Phil
I will be putting the chip upgrade in from mark at blitzracing (4.0 tvr non cat) but wanted to get initial gremlins ironed out first.
Have a quick question re the 14cux. Fitted 3.9 with lt77 in Mgb gt, been on carb it’s now on injection off RR.
Had it running but wouldn’t idle unless I popped a washer under the idle stop on the plenum, but it warmed up and would restart etc
Anyway, one question is roverguage shows a fault that it’s in rev/drive? I have fitted a 510ohm resistor to ground on the orange and black wire, but still reading it as an auto.
Secondly is the inability to start on tickover due to 3% throttle position (without washer) and my maf voltage 1:25v which is low?
Thoughts greatfully recieved
Phil
I will be putting the chip upgrade in from mark at blitzracing (4.0 tvr non cat) but wanted to get initial gremlins ironed out first.
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff