New guy Just bought a CV8
Discussion
They are part number MDC1941. They are 360x30mm rather than 362x32. This isn't a problem and pad still make full contact.
The issue is that you need to make a centre Spiggot to fit between the hub And the disc (71.5mm to just a thou under 79mm and 7mm thick) I also made a set of ten spacers to slide over the 12mm studs to take them to 16mm of the Range Rover
Another potential issue is the mounting surface is 2mm thinner than the AP so if your wheels are close it could make it worse. I Had a pair of 3mm so popped them on until I get new wheels
The issue is that you need to make a centre Spiggot to fit between the hub And the disc (71.5mm to just a thou under 79mm and 7mm thick) I also made a set of ten spacers to slide over the 12mm studs to take them to 16mm of the Range Rover
Another potential issue is the mounting surface is 2mm thinner than the AP so if your wheels are close it could make it worse. I Had a pair of 3mm so popped them on until I get new wheels
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff