New guy Just bought a CV8
Discussion
Most of my money has been going into the house recently but I’ve managed to spent a scrap on the monaro. The display on the original head unit was dead so upgraded to a Sony with a few more features. Also turned the amp up a little and I’m very pleased with the sound. Pic shows before the facia plate kit turned up
It’s been a busy day in the garage today. Yesterday evening a package arrived in the post all the way from eBay
I’ve wanted to fit a set of these exhaust cut outs since seeing some you tube vids.
I usually hate anything to do with exhaust work when no ramp is available but this job really went to plan!
The kit seems very good quality
The only snag being that there wasn’t space to fit the full Y section in as we needed enough room to fit the motors too
As you can see below we ended up cutting in the diverting section into the pipe rather than the full section, this was I little more fiddly but ended up a far more compact and neat job. We coated the weld in silver VHT paint to prevent corrosion
Now all wired in and working a treat! Sounds evil, I can’t wait to test it on the road but I can’t even get it up the drive currently due to snow so it will have to wait.....
I will try and get a vid up if I can get a good recording but I only have my phone which is pretty terrible
I’ve wanted to fit a set of these exhaust cut outs since seeing some you tube vids.
I usually hate anything to do with exhaust work when no ramp is available but this job really went to plan!
The kit seems very good quality
The only snag being that there wasn’t space to fit the full Y section in as we needed enough room to fit the motors too
As you can see below we ended up cutting in the diverting section into the pipe rather than the full section, this was I little more fiddly but ended up a far more compact and neat job. We coated the weld in silver VHT paint to prevent corrosion
Now all wired in and working a treat! Sounds evil, I can’t wait to test it on the road but I can’t even get it up the drive currently due to snow so it will have to wait.....
I will try and get a vid up if I can get a good recording but I only have my phone which is pretty terrible
Sorry to mention this but noticed on photo what looked like rust on the main member near to cutout, If this is so, please correct ASAP or your lovely car is not going to last. And yes you have decided to do the right thing fitting cutouts, the sound is great, I too have some.
Enjoy
Ade
Enjoy
Ade
THUNDER STORM said:
Sorry to mention this but noticed on photo what looked like rust on the main member near to cutout, If this is so, please correct ASAP or your lovely car is not going to last. And yes you have decided to do the right thing fitting cutouts, the sound is great, I too have some.
Enjoy
Ade
Thanks Ade, I’m a little apprehensive of the new mot rules but as the cut outs are built into the cats (high flowing sort) I can just bolt in standard cats if I have to.Enjoy
Ade
If the rusty area is the bit with the three round holes in, disappearing off to the top of the pic? That is just the brake pipe channel so not structural. If not then please feel free to point it out and I will get right on it!! That said, undersealing treatment is definitely on the cards, there are a few areas where the original paint is going flakey now on inner sills and around rear subframe etc so want to get it treated before it gets worse
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff