Windscreen Washers

Windscreen Washers

Author
Discussion

DHilly

Original Poster:

203 posts

234 months

Saturday 29th April 2017
quotequote all
Hi all
As the title, bottle full and I can hear the motor running but no water out of the jets. After a couple of minutes water appears from the nearside front wheel arch near the outrigger? Anyone know where the pipework runs and how to get to it?

Cheers

Toolbox200

131 posts

125 months

Saturday 29th April 2017
quotequote all
Pipe goes through the inner wing and into the cabin behind the carpet on the right hand side a foot or so above the floor.....it then goes up into the dash area, over the steering column and into a void between the bulkhead and dashboard. My feed pipe came away from the tee pieces going to the jets. Some have managed to female the connection from outside but I had to remove the dashtop and gain access to the removable panel in the dash area. God luck finding the problem...Pete

DHilly

Original Poster:

203 posts

234 months

Sunday 30th April 2017
quotequote all
Thanks Pete, I found the problem, pipe had a hole in it in the inner wing area, had to cut the pipe in the footwell and connect a lenghth of new pipe to the end of the old pipe and then carefully pull the old pipe from the bottle end (after taking off the front grille) pulling the new pipe with it. Luckily all went well but if the pipes had become disconnected whilst I was pulling them through god only knows what you would do? propoably have to cut a hole in the inner wing behind the wheel?

Had the dash off but I don't have an access panel to get to the pipes behind the dash, mines a 1995 car so maybe the access panel was added to later cars

LenChim

225 posts

155 months

Monday 1st May 2017
quotequote all
DHilly said:
Thanks Pete, I found the problem, pipe had a hole in it in the inner wing area, had to cut the pipe in the footwell and connect a lenghth of new pipe to the end of the old pipe and then carefully pull the old pipe from the bottle end (after taking off the front grille) pulling the new pipe with it. Luckily all went well but if the pipes had become disconnected whilst I was pulling them through god only knows what you would do? propoably have to cut a hole in the inner wing behind the wheel?

Had the dash off but I don't have an access panel to get to the pipes behind the dash, mines a 1995 car so maybe the access panel was added to later cars
It can be done but is a serious pain as I found out when I bought my car, the pipe was missing all it did when I pressed the washer was make a nasty wet patch on the floor. Stiff wire and lots of patients.