2014 RR bonnet alignment
Discussion
I just bot a used 2014 reg range rover vouge se from a 4x4 specialist. Everything of the car is fine except the bonnet alignment. When i close the bonnet, there is a significant gap between the bonnet and the lamp & side panel on the driver side comparing with the passenger side.
The dealer told me to twist the rudder pins located under the hood each side, i tried to fasten the driver side and loosen the other one but no good result, gap is still there, it seems solid and physical.
What else can i try? anyone experiencing the same problem before please help.
Thanks J
The dealer told me to twist the rudder pins located under the hood each side, i tried to fasten the driver side and loosen the other one but no good result, gap is still there, it seems solid and physical.
What else can i try? anyone experiencing the same problem before please help.
Thanks J
I'm not sure about that...... The car shouldn't really have any kind of gap that doesn't match the opposite side - I'm sure it would have matched when it left the factory.
I guess it's a used car so may have had a repair at some point, it doesn't necessarily mean it's a bad car.
Of course not all damage / repair is recorded, only if it's over a certain level of damage and / or reported to an insurer.
Post a photo if you can, some people may be able to tell you more....
I guess it's a used car so may have had a repair at some point, it doesn't necessarily mean it's a bad car.
Of course not all damage / repair is recorded, only if it's over a certain level of damage and / or reported to an insurer.
Post a photo if you can, some people may be able to tell you more....
Gassing Station | Land Rover | Top of Page | What's New | My Stuff