Quick release steering wheel
Discussion
Hi, I wonder if anyone could help or direct me to someone with a boss to fit directly on to the drive shaft which holds the steering wheel rather than cutting the shaft short and welding a "slug" on or if anyone has a spare one. I have a Momo steering wheel. Appreciate any help or suggestions
meteor here http://www.meteormotorsport.com/caterham/hardware/... do one that come with the bit of shaft with the welded bit already on it, so it's a simple bolt on job to fit it. I have one, and it is far superior to the original caterham one .. recommended!
johnvthe2nd said:
meteor here http://www.meteormotorsport.com/caterham/hardware/... do one that come with the bit of shaft with the welded bit already on it, so it's a simple bolt on job to fit it. I have one, and it is far superior to the original caterham one .. recommended!
If I get a quick release wheel, I will buy one of those. The fact that it's easier to put on isn't as important as the way the design eliminates the problem with play in the splines. I don't know why Caterham don't offer it.johnvthe2nd said:
it does move the steering wheel out by about 1cm .. I was concerned about this at first, but you really don't notice it (well, I didn't)
Which will actually stop you breaking off the main beam toggle switch during frantic use of the wheel! I've always set my column around 1cm further out than standard to give more finger room behind the wheel - easily adjustable at the upper/lower column join whether QR or standard.Stu.
Forums | Caterham | Top of Page | What's New | My Stuff


