Throttle cable for 2.9 ford cologne engine broken on S4
Discussion
Barry S1 said:
That's not the right part. Burtons don't sell the right part. Are you suggesting that can be made to fit, by changing the pedal end of the inner cable, and modifying the outer mounting at the other end? If that's the case it would be helpful if people knew that it's not a straight swap.
Hi all.
Yes, the cable I sold was a "make to fit" one.
It was great to meet scubaman yesterday who drove all the way from London for some of my S parts. A very nice chap indeed!
I was going to use a Capri 2.8 cable and weld the ball joint of a ford pedal on to the S one.
I see no reason why this cannot be done and it would also eliminate the rather crude "hacksawn slot" TVR method of attaching the cable to the pedal.At the engine end, either a smaller square holed plate could be fitted to the cable bracket or you may be able to modify the nylon screw fitting off the old cable as the Capri one is slightly smaller.
More food for thought?
Chris.
Yes, the cable I sold was a "make to fit" one.
It was great to meet scubaman yesterday who drove all the way from London for some of my S parts. A very nice chap indeed!
I was going to use a Capri 2.8 cable and weld the ball joint of a ford pedal on to the S one.
I see no reason why this cannot be done and it would also eliminate the rather crude "hacksawn slot" TVR method of attaching the cable to the pedal.At the engine end, either a smaller square holed plate could be fitted to the cable bracket or you may be able to modify the nylon screw fitting off the old cable as the Capri one is slightly smaller.
More food for thought?
Chris.
i think mine was a sierra one with the engine end modified as follows
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
Forums | S Series | Top of Page | What's New | My Stuff